Framewrap is waterproof and oil resistant and will stay in position until you take it off. Moisture and grit can't get behind Framewrap like it does with neoprene protectors and when it comes time to removal, it will leave no sticky residue behind.

1 roll of Framewrap is more than enough for a thick wrap for a mountain bike chainstay.

Other uses
There's many other uses. You can use Framewrap to wrap your crank arm for added protection from the nasties of the DH shuttle trailer, you can tape off bar tape, cinch cables closer to the frame maybe even repairing a torn sidewall or radiator hose. Keep some in your pack for emergencies.

Installation
Clean the surface of your driveside chain and seat stays. Remove the backing liner from the roll in lengths of about 150mm to 200mm at a time. Snip a little off the sides on the free end of the tape to make a wedge shape to make it easier to pin down to the frame with your thumb. Place the end of the Framewrap onto your frame and stretch the Framewrap over and under the stay, creating an overlap of 1/2 to 2/3. Stretching and overlapping the wrap activates the self fusing properties of the tape. Repeat this 'stretch and wrap' action until you get to the end of the roll and then press your thumb firmly on the end to bond it to the wrap beneath. Install complete. Ride bike.